The hydraulic breaker can be used to excavate the foundation of a building more effectively to clean up the floating rocks and the soil in the crevices of rocks. So what should we pay attention to when breaking hammer is in construction? Below the hydraulic breaker manufacturer, let us know about it. I hope it will help you.
1. Pay attention to the operation time. The hydraulic breaker manufacturer reminds you that the hydraulic breaker should not strike continuously at the same point during crushing operation. If the target can not be broken by striking continuously for more than 30 seconds at the same fixed point, please change the selected point to try again. When crushing a particularly hard object, it should start at the edge. Constant blow at the same point will cause excessive loss of drill rod and overheating of hydraulic oil.
2. Choose a good job. The hammer should be kept perpendicular to the material and the drill rod will be pressed against the broken object. If the direction of hammering is inclined, the steel brazing is easy to slip off during hammering operation, which may cause the fracture or jamming of the steel brazing and piston.
3. The appropriate breakdown force should be selected in the crushing operation of the hydraulic breaker. If the breakdown force is insufficient, then the hammering energy of the piston will not be able to effectively crush the stones. The reaction force of the hammering force will be transmitted to the hydraulic breaker body and the bearing machine of the hydraulic breaker, thus damaging these components. If the breakdown force is too large, the machine may suddenly tilt in the moment of gravel, and the hydraulic breaker will hit the stone violently, which will also cause damage to the hydraulic breaker.
A little carelessness in the operation of a hydraulic breaker will cause great harm to it. If the hammer is properly used, it will greatly extend its life. Above is hydraulic breaker manufacturer to share with you, hope to help you. Also want to understand the contin